Newer top-load Maytag washers usually have suspension rods down the sides of the cabinet that support the tub, and some may have suspension straps between the tub and the side of the washer cabinet.ĭiagnosing an issue with suspension components is difficult without removing the top and front panels. Top-load Maytag washers usually have snubber rings or pads that support the bottom of the tub, as well as springs that secure the tub to the bottom of the washer (more common in older washers). If any of these suspension components are defective, it will cause the washer to make a lot of noise.įront-load Maytag washers have two suspension springs that support the drum from the top and shock absorbers that support the bottom of the drum. Check and replace suspension componentsĭepending on the type and age of your washer, it will have various components responsible for the suspension of its tub or drum when the whole washer is in use. Replacement seals are usually included in replacement tub bearing kits. If you need to replace the tub bearing, it is recommended that you go ahead and replace the tub seal as well. Access to the bearing requires dismantling the washer, removing the tub, the stator, and the rotor. With top-load washers, the tub bearing is mounted to the underside of the tub. However, typically, you will need to dismantle most of the washer, which will require your removing the door, front panel, and rear access panel – then you’ll have to remove the drum from the washer. With front-load washers, the tub bearing is located on the rear of the outer tub. Mainly due to its hard-to-reach location, replacing a tub bearing is a difficult and time-consuming repair, so it may pay to have a trained technician replace it.Īccessing the tub bearing will depend on the type of Maytag washer that you have. If the noise seems to come from the bottom-center of the washer, a worn-out tub bearing is most likely responsible. However, you can try and diagnose the issue by listening to where the noise is coming from. In fact, not all Maytag top-load washers even have tub bearings. If you have a Maytag top-load washer, it can be more difficult to determine if your tub-bearing has failed. These are created when the basket grates against the front of the washer. If the tub bearing is defective, the basket will be loose and won’t quickly return to its initial position.Īnother symptom of a bad tub bearing is plastic shavings. Next, lift up and push down on the basket and see how secure it is. If it is loose, it will vibrate more than usual and make a lot of noise- that indicates the tub bearing needs to be replaced. First, turn the drum and see how loose it is when it spins. If you have a Maytag front-load washer, you can determine if the tub bearing is worn out, and causing the noise issue, by inspecting the drum. This guide applies to most Maytag washer models, including the following: Make sure to disconnect the power and water to your washer before performing any repairs. However, checking and replacing suspension components is relatively easy. Unfortunately, replacing the tub bearing or spider support arm is a complicated and time-consuming repair that you may want to leave to a trained repair technician. If the tub bearing is not responsible, one of the suspension components or the spider support arm (front-load washers only) is likely responsible for the noise issue. If your Maytag washer is making loud noises during its spin cycle, the most likely cause is a worn-out tub bearing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |